by Custard » Wed Jun 07, 2017 7:47 am
Are the KA seats the same as the Puma ones?
I thought they were, in which case there are two issues,
1) Replicate the mounting for the sill mount for the belt as there is no plate to bolt down, just a stitched loop in the belt for the metal bar to go through and that bar only bolts in at one end the other slid in a hole. So it was either work out how to use that bar or make another bar that could be bolted to the sill.
2) The clip goes into the seat which seems to be why the rear corner of the seat has two bolts when the rest have one, so that area of the seat definitely needs to be very secure and the floor probably plated underneath, or at least use spreader plates not just washers on the bolts.
If you have a 2 door car then the slim pillar means you have a less than ideal upper mount too.
Sean.